Pioneer Blu-Ray Universal Remote Codes & Program Instructions

Basically the Pioneer Blu-ray player supports so many universal remotes, if you have a remote with you and are looking for Pioneer Blu-ray universal remote control codes then we are here to give you advice on how to program remote controls. Universal remotes with pioneering Blu-ray players. We have also provided various kinds of universal remote codes. So check it out now.

Pioneer Blu-Ray Universal 5 Digits Remote Codes

  • 21571
  • 20571
  • 22442
  • 20142
  • 21460
  • 21512
  • 20632
  • 20631
  • 20525

Pioneer Blu-Ray Universal 4 Digits Remote Codes

  • 0678
  • 0750
  • 0837
  • 0876
  • 0701
  • 0702
  • 0719

Universal All-in-One Remote Control Codes for Pioneer Blu-Ray Player

  • 21571
  • 0750

How to program the Pioneer Blu-Ray universal remote control without codes

In the automatic search method, all universal remote control codes have gone through a scanning process in the remote control. It scans one code at a time to find the correct remote code that works with your remote to program the command. Follow the instructions below:

  1. “Light up” smart device like “TV” that you want the universal remote to work.
  2. “Light up” remote control, press the button on the device (TV, DVD, CBL and OK / SEL) for 3 seconds. The LED indicator indicates that the device is ready to be programmed.
  3. Point the remote control at the device and click “CH +” & “CH-“ switches. The remote will display the on / off signals. hurry “up” Where “down” continuously until the device switch off.
  4. Check the code by clicking on “Power” key. The device must light up. If it starts, try changing the channel to verify that the remote is correctly programmed.
  5. Now press the “device” button to save the code. The device LED will blink twice to confirm the stored code.

How to program Pioneer Blu-Ray Universal remote control with manual method

Using the key code we can easily program a universal remote control and the key code identifies the make and model of your equipment.

How to program the Pioneer Blu-Ray universal remote control with Code search

If you can’t find the key code that works for the device at that time, you can configure your universal remote to search for the correct one. It’s a code in the manual that forces the remote into search mode

  • First of all “Turn on the device”
  • Now press and hold the “To install” button
  • Enter the “9-9-1” code (three digits)
  • Now hold the “Power button” on the remote control, then press the channel upwards until the device in this case your TV “Off”

The above method may take a little longer, but finding your key code is very important. Once you have completed the above procedure, your remote control should work for all in functions.

We hope the above methods and codes have been used to program your Pioneer Blu-Ray player and also for your favorite remote control. These methods are used for setting up the remote control of the Pioneer Blu-Ray player.

Conclusion:

If you feel good with this article then please give us a feedback, it will give us a boost to improve our site and reach many aspiring those who are waiting for their remote control codes, we are also accepting new ones universal remote control codes these will work for you, please leave these codes in the comments section below, we will also pass them on to other users by posting them on our site.

Rate this post

Leave a Comment